Does anybody have access to the plans for the Z axis Spindle Assembly for a TL2.
The reason I ask, is that we have just had the machines serviced and it was found the assy needed replacing. The machines will be serviced again in 6 months and we will get the neccessary repairs done then.
The only things is I just got a quote from Haas for nearly £900. That seem somewhat excessive for a couple of bearings and a shaft.
If someone has the drawings of the parts we would make it ourself and just get the bearings ordered in.
It's a long shot, but I thought I'd ask on the off chance
The reason I ask, is that we have just had the machines serviced and it was found the assy needed replacing. The machines will be serviced again in 6 months and we will get the neccessary repairs done then.
The only things is I just got a quote from Haas for nearly £900. That seem somewhat excessive for a couple of bearings and a shaft.
If someone has the drawings of the parts we would make it ourself and just get the bearings ordered in.
It's a long shot, but I thought I'd ask on the off chance