so,
I run a wizard, set up the 'default support bridges' on my model and the tool paths cut AROUND the freaking bridges, whats the point in bridges if it's just going to cut around them? I can work around it obviously by putting my own bridges when I model then using a subsegment to make sure it doesn't cut around them but really? it treats the support bridges like the original model and just cuts em out like everything else. Just wasted 8 hours of machine time (my own fault really, I should have noticed in the toolpath that it was going around the bridges) because of this and while I blame myself, it doens't make it any less frustrating that it handles support bridges this way.
I run a wizard, set up the 'default support bridges' on my model and the tool paths cut AROUND the freaking bridges, whats the point in bridges if it's just going to cut around them? I can work around it obviously by putting my own bridges when I model then using a subsegment to make sure it doesn't cut around them but really? it treats the support bridges like the original model and just cuts em out like everything else. Just wasted 8 hours of machine time (my own fault really, I should have noticed in the toolpath that it was going around the bridges) because of this and while I blame myself, it doens't make it any less frustrating that it handles support bridges this way.