PUMA 2500SY Spindle Sync

I'm having trouble getting my spindles to sync RPMs, I normally do it when picking up a part and parting off, but in this case I am chucking a center in the sub and using it to steady a thin part for turning. I tried using M203 but get a alarm about my chuck condition, I assume it's because it's in closed position. So, just to get the parts going I used M206 for each spindle which sucks but works, only problem is when I call up my tool geometry, T1212, I get an alarm saying tool offset not allowed in polygonal mode?

Old Code:
N5
( SUB SPINDLE ON PART )
G18
G0G30U0V0
G30W0B0
T1212
G97S500M3
G55G0Z-2.125
G97S500M203(<--- alarm )
G0B-18.5
M86
G1G98B-19.13F10.
G99
M87

N6
( TURN OD - VNMG NEUTRAL )
G18
G30U0.V0.
G30W0.B0.
T1212
G50S3600
G97S2193M3
/M8
G55G0X6.Z.05
G96S600
X1.
X.375
G99G1X.235F.005
Z-1.375F.006
G0X.375
Z.05
X.25
G1X.218
Z-1.375F.004
G0X6.M9
G30U0.V0.
G30W0.B0.
T1200
M1

Current Code:
N5
( SUB SPINDLE ON PART )
G18
G30U0V0
G30W0.B0.
T1212
G55G0Z-1.
G50S3000
M206
G96S500M3
M206
G96S500M103
G0B-16.6
M86
G1G98B-16.827F10.
G99
M87

N6
( TURN OD - VNMG NEUTRAL )
G18
G30U0.V0.
G55G0Z-.5
T1212 (<---- alarm )
G50S3600
M206
G97S2193M3
M206
S2193M103
/M8
G55G0X6.Z.05
X1.
X.375
G99G1X.235F.005
Z-1.375F.006
G0X.375
Z.05
X.25
G1X.218
Z-1.375F.004
G0X6.M9
G30U0.V0.
T1200
M1