See page 86 of this document
http://www.servo-repair.com/document...otor/SX_UG.pdf
four wire implementation!
Solid units, like the S-drives before.
If you have an SX drive, and want to use it with LinuxCNC or Mach etc.
I've seen posts that indicate otherwise, this one suggests possibilities. http://www.cnczone.com/forums/393693-post7.html
YOU-CAN-DO-IT!
cheers
Cal
http://www.servo-repair.com/document...otor/SX_UG.pdf
four wire implementation!
Solid units, like the S-drives before.
If you have an SX drive, and want to use it with LinuxCNC or Mach etc.
I've seen posts that indicate otherwise, this one suggests possibilities. http://www.cnczone.com/forums/393693-post7.html
YOU-CAN-DO-IT!
cheers
Cal