A Few Measurements Needed...

Guys,

I'm working on a couple of (for now...) top-secret projects. I need a few measurements for both the PCNC770 and PCNC1100, if anyone could take a few minutes to measure these, I would appreciate it. These don't need to be extremely accurate - quick tape measure measurements accurate to 1/4" or so is fine for now.

Here's what I need:

Diameter and length of spindle nose (the small diameter part the collet goes into)
Distance from underside of spindle nose to underside of head casting
Distance from spindle centerline to front-most face of column
Width of head at spindle
Width of column behind head

Thanks!

Regards,
Ray L.