could somebody please calculate this feed and speed for me please? the setup is:
sherline cnc mill
2800 rpm
cut is .010" deep, full slot
ball mill, .020" dia, .030" flute length, 2 flute, 1/8" shank
stickout will be very little, this is for engraving text on flat surface
material is ABS
i can also use a 4 flute with the same specs otherwise
carbide or hss are options
it would be nice to know how deep i can go, .015" or .020" deep might come in handy..or to know if I can only go 0.005"..which is also usable
just trying to see if the 10000rpm pulley set is a must..or if this is reasonable at 2800 rpm. i will be engraving quite a bit of text and it needs to look nice without breaking bits..
thanks for any help!
sherline cnc mill
2800 rpm
cut is .010" deep, full slot
ball mill, .020" dia, .030" flute length, 2 flute, 1/8" shank
stickout will be very little, this is for engraving text on flat surface
material is ABS
i can also use a 4 flute with the same specs otherwise
carbide or hss are options
it would be nice to know how deep i can go, .015" or .020" deep might come in handy..or to know if I can only go 0.005"..which is also usable
just trying to see if the 10000rpm pulley set is a must..or if this is reasonable at 2800 rpm. i will be engraving quite a bit of text and it needs to look nice without breaking bits..
thanks for any help!