I'm using this with a bladerunner system with the rs485 connect kit and the DCC on the bladerunner. I'm getting a fault code 0-11 on the pm85. That particular code is not listed in the hypertherm manual. The table is cutting the file ok with some dross but i'm attributing that to user error (file setup in sheetcam) at this point, unless the fault code might have something to do with it. I'm getting a fault code in mach, that says "HT fault 0-11-2 gas pressure setting value is out of range". I thought, when set to auto, that the pm85 automatically sets it. OR is the input pressure from the compressor not set correctly. It's currently set at 120psi at the compressor. There are no problems at the compressor maintaining pressure, it's a 2 stage, rated at 17cfm@90psi. Any help would be appreciated.
Thanks
Marcel
Thanks
Marcel