Hey All,
I have been switching between my collet holder and my chuck holder on the X3 for years now. Today when I went to put in my chuck holder, it wouldn't go in. I filed the top a touch to make sure the groove was easy for the pin to align with. But no go, it only goes into the spindle about half way. I used my calipers and everything measures the same between my collet holder and my chuck holder. Do any of you know what might be causing this?
Joe
I have been switching between my collet holder and my chuck holder on the X3 for years now. Today when I went to put in my chuck holder, it wouldn't go in. I filed the top a touch to make sure the groove was easy for the pin to align with. But no go, it only goes into the spindle about half way. I used my calipers and everything measures the same between my collet holder and my chuck holder. Do any of you know what might be causing this?
Joe