Hi,
Just wondering if anyone has a post processor that works for mach, i found a few questions about it when i searched but no real concrete answers, i have trouble with the i and j with the burny pp and others contain unrecognised words and commands, none seem to give any z output either, presumabl this is because an industrial thc system controls the z axis?
Im looking to try the product and im encouraged by the things it can do that sheetcam wont, reducing feed on smaller circles, edge starts, back to back stuff etc etc but i need to be able to make it work for me.
thanks
matt
Just wondering if anyone has a post processor that works for mach, i found a few questions about it when i searched but no real concrete answers, i have trouble with the i and j with the burny pp and others contain unrecognised words and commands, none seem to give any z output either, presumabl this is because an industrial thc system controls the z axis?
Im looking to try the product and im encouraged by the things it can do that sheetcam wont, reducing feed on smaller circles, edge starts, back to back stuff etc etc but i need to be able to make it work for me.
thanks
matt